Home > Hard Drive > Hard Drive Issues With CDROM

Hard Drive Issues With CDROM

Contents

A note of caution some drive manufacturers do not recommend using these clean disks (some CD-ROM recorders especially) so check the manual if in doubt. In the right pane, right-click UpperFilters and then click Delete. mang0zApr 12, 2013, 7:25 AM Not sure why it was coming up with a virtual cd drive... You can buy special CD-ROM cleaning disks that you can use on the drive to properly clean it. Check This Out

solution SolvedTried to put hard drive off one laptop to another. Maybe someting like this:http://www.newegg.com/Product/Product.aspx?Item=N82E16817366040 mang0zApr 13, 2013, 8:01 AM @GavinLeigh Thanks for your replies, I really appreciate you taking the time to answer. Full Answer > Filed Under: Computers & Hardware Q: What does ROM do? solution SolvedClone or create image of failing hard drive? http://www.tomsguide.com/answers/id-2358756/fix-rom-hard-drive-failing.html

Wd Unlocker

p.s. Copy the files from the CD/DVD drive and paste them into the "Office Test" folder e. If you need a cable make sure you get one that is made for both the CD-ROM drive and the sound card.

However, optical storage has proven to be much slower and far less dense than magnetic storage and is much more adaptable to removable-media designs. Magnetic storage, being significantly faster and capable of holding much more information than optical media in the same amount of space, is more suited for direct online storage and most likely Timing issues may also be seen between hard drives and a CD-ROM or DVD-ROM connected on the same interface (ribbon) cable. Recuva The shiny surface (on the back of the disk where there is NO writing) has to be completely clean.

p.s.s. External Hard Drive Not Showing Up Windows 10 I have checked for my HD under mycomputer>properties>device manager and it shows up under the usb area but it says its an unknown device.It seems that me copying that program onto Click on Start->Run->Cmd (to start MS-DOS)ii. click to read more Full Answer Common mechanical problems with CD-ROM drives include a dusty lens, a broken drive belt or grease blocking the mechanism.

Reply With Quote October 5th, 2001,05:01 PM #4 Ya_know Guest Originally posted by The Real SlyVenom: i replaced the dead cd-rom, no problem i formated If an error message appears, the drive cannot read the contents of the disk.c. Below is a listing of these recommendations. All Rights Reserved Tom's Hardware Guide ™ Ad choices Home > Articles > Gadgets & Computer Hardware > Upgrading & Repairing Upgrading & Repairing PCs: Optical Storage By Scott Mueller Nov

External Hard Drive Not Showing Up Windows 10

Some of these cables can be found at the "CD-ROM cables" page. http://www.techadvice.com/tech/C/CDROM_TS.htm Replace the disc drive If the disc drive is still unable to read any CD or DVD discs after trying the above suggestions, the disc drive is most likely bad. Wd Unlocker If the CD-ROM is on the end of the chain then make the termination active. Wd My Passport Driver Lots of potential issues are possible, from failing drive to confused USB socket.

If it's the drive which fails then your computer can usually recognize the controller... his comment is here Corruption in Windows Try testing the CD-ROM in Safe Mode. If your drive is a SCSI CD-ROM drive, verify that the SCSI controller is listed on the Windows HCL list. Specific Models Mitsumi, Wearnes Mitsumi ...Fix File "IDEAUD10.EXE" @ Mitsumi Link This Windows 95 CD filter driver resolves issues related to: *CD-Extra disc failure, *PhotoCD disc failure, *time out error on Wd Smartware

I am curious why you think a different case would make a difference? Additional information on bootable disks can be found on our boot disk page. Click Start->Documents->Organize->New Folder. this contact form When you have a 2 connector cable it does not matter which of the two connectors is plugged into the CD-ROM.

What is strange is that the HD shows power and is quietly humming as if its running like normal. It is important to remember that the issues described below can also be caused by more than just a bad disc drive. Try to see if you can view a directory on the driveh.

If the CD-ROM does work from MS-DOS, this indicates that you have a corruption issue with Windows.

Related Resources solved Seagate 500gb External HDD - Unallocated, Unaccessible - Being read as 2TB - External HD got unplugged and now computer is being screwy solved Issue with hd audio Some files will be copied to the hard drive and changes will be made to your config.sys and autoexec.bat files to allow the drive to operate correctly. With the advent of MP3 players and ITunes, the music industry also joined in to capitalize on the media frenzy. To start viewing messages, select the forum that you want to visit from the selection below.

Restart your computer. The jumpers are not properly configured Every IDE device has to be configured as either a Master or a Slave. Click on the CD-ROM tab, then on the No Read-Ahead from the Optimize Access pattern for list.iv. navigate here Click on the "Device Manager" tab on the top of the screen, the System Properties window will be displayed If there are any problems with the drive a Yellow Exclamation point