Home > Have I > Have I A Faulty Disk?

Have I A Faulty Disk?

YMMV.

October 11, 2013 Lady Fitzgerald Even better is to have a good backup scheme in place so, if a HDD goes to computer Never-never Land, you don't have to worry Then the load of the HDD (writing to two partitions simultaneously) will be reduced.

From: ttr Reply Nope, if there are multiple arrays on one drive to be sync, they Comparing /proc/mdstat from before and after will confirm the drive that failed. The motor burns out, the drive overheats, bearings get stuck—the kind of thing you’d expect to find when a car fails.

This was just the article I needed after one of my disks failed and I had to get the array back up and running. Because as the old adage goes, "it's not if the hard drive will fail, but when." - My drive has been replaced, now trying to re-populate it with recovered or replaced If you get to that part, it is possible to dig into it further (more steps than can be described here) within the BIOS to see if the hard-drive is found use cat /proc/mdstat to se that md1 was on sda2 and md2 was on sda3 3.

In some cases, it's possible for sectors on the hard drive to contain data that doesn't match their error-correction code -- this would be marked as a bad sector. I could find no differences. Do not EVER attempt to rebuild a RAID unless ALL of the hard disk drive members are present, accounted for, confirmed to be fully functional individually, connected in the correct sequential Had a single isolated BSOD on the system when playing a DVD qbout a week earlier but then it recovered fine until this morning.

add a comment| 2 Answers 2 active oldest votes up vote 8 down vote accepted From an elevated command prompt run diskpart. If you were asked to sing or do other weird things at a job interview, does this mean that the employer is not taking you seriously? Your computer can turn on without a hard drive. Don’t try to be a hero.

If you can never afford it, try the drive again sometime. Very satisfying to be able to replace a failed hard drive with less than half an hours down time. Flag as... http://www.wikihow.com/Tell-if-a-Hard-Drive-Is-Bad EDIT Edit this Article Home » Categories » Computers and Electronics » Hardware » Internal Components » Hard Drives ArticleEditDiscuss Edit ArticlewikiHow to Tell if a Hard Drive Is Bad Community

Select > Properties, in the window that opens switch to the > Tools tab and click > Check now… In the Checking Disk window place a checkmark next to > Automatically Operating system unable to boot. Computer Organization and Design, Revised Fourth Edition: The Hardware/Software Interface. It sounds like a muffled coffee grinder under a pillow in the next room, not too loud but you can feel it when you place your hand on the pc.

The air filters on today's drives equalize the atmospheric pressure and moisture between the drive enclosure and its outside environment. http://serverfault.com/questions/438546/how-to-know-which-disk-has-failed-on-a-mirrored-raid-marked-as-dr0 Which meant no music software. For these cases, I recommend to keep a copy of your most important data in a different physical location, for example at work or with a friend, or possibly on a There are two types of bad sectors -- one resulting from physical damage that can't be repaired, and one resulting from software errors that can be fixed.

How-To Geek Articles l l How Do Night Vision Cameras Work? Why aren't electric forms of heating used in internal combustion engines ¿Es "la azúcar" o "el azúcar"? However the company states that it mainly uses commodity consumer drives, which are deployed in enterprise conditions, rather than in their representative conditions and for their intended use. We can do this with one simple command: sfdisk -d /dev/sda | sfdisk /dev/sdb You can run fdisk -l to check if both hard drives have the same partitioning now.

Of course, it could be that your kids moved your files for fun or a virus is eating through them, but disappearing data is never a good sign for your drive Glad to hear, Diana. As with all data storage, back up regularly! Likely the short life of disks is all part of the consumer, money thing..

For example, the Seagate Barracuda 7200.10 series of desktop hard disk drives are rated to 50,000 start–stop cycles, in other words no failures attributed to the head–platter interface were seen before Bairavasundaram, GR Goodson, S. Certain trends and sudden changes in these parameters are thought to be associated with increased likelihood of drive failure and data loss.

This can be done with any array type.

Errors when reading, copying, moving, or deleting data on the computer. asked 4 years ago viewed 9271 times active 4 years ago Linked 4 Can't boot after Disk 0 of software raid is replaced Related 4HP Onboard Software SATA RAID. If either the drive or the media is dirty, users may experience the buzz of death when attempting to access the drive. It may even be an issue with the screen itself.

It hurts. Nevertheless the disks are of exact the same size and geometry. I think, with any backup solution you will eventually face data degergation in some form after some time - even cheap dvd's, so my advice is, despite whatever media you use, type 'install (hd1)' 9.

Video Tips Logical Failures: Logical failures occur when the electronics of the hard drive failure or the software (firmware) has a problem. Couple of years ago, I went back to XP - which I still use - from 7 because none of my lovely music software liked 7 even in XP mode. Oh shit I say...I look and can still see my 4 drive partitions (a 1TB drive split into 4) but as I start to try to copy stuff off, too late. Why is SSH not resolving this hostname?

What Is "Differential Privacy," and How Does It Keep My Data Anonymous? For more information how to back up data, read my PDF manual Stuff Happens: The Backup & Restore Guide.